Bushings are rubberized sleeves or linings that reduce friction or vibration at.

the slickest way if your handy with a welder is to wipe all grease out of the spindle, so it will not burn you, then run several beads of weld at low heat onto the inside of the bushing, let it cool on its own and the weld will shink and loosen the bushing allowing you to use a hammer and bar to drive it out, use low heat, you only want the weld on the inside of the bushing, not weld the bushing to the spindle, and.

Jul 10, get out your handy-dandy Dremel with the little round high-speed Burr, and cut a slot through that bronze bushing. Doing so will relieve the press-fit pressure and it should fish out easily. The burr will cut the bronze easily and quick. If you cannot get a bushing, you can have a local machinist cut one for you to your specs.

1) Place the tool into the bushing 2) Thread in a 12" long piece of 3/4" steel pipe into the tool just hand snug. 3) Drive the steel pipe with hammer blows on the free end of the pipe.

The hammer blows will advance the pipe, tool, and bushfalling.bar date: May 10, Aug 20, pressing the old bushings out of my rear knuckle spindles.

Jan 26, Remove the bushing manually by striking it out with a hammer. This is the most tree brush clean up and least effective method for removing the bushing, but if you don’t have a hydraulic or threaded press it will work with some patience. Be careful not to hit the control arm, focusing each strike on the bushing 83%(22). Jul 17, Bolt completely out of arm on top of steering spindles (that connects the long drag link).

Next tap the steering link upwards over the top of the spindles. Then remove the woodruff key.

The first step is to cut a channel on the inside if the bushing.

The spindles will then slide out of the bottom of the axle support. The bushes can be tapped out by using a.

Oct 13, 1) Remove the center insert with a small bushing press (easy) 2) Saw through one side of the sleeve (PITA because you have to watch for going too far into housing, which i did) 3) Created a lip on the sleeve and used an air chisel on the bushfalling.barted Reading Time: 7 mins.