Learn why people trust wikiHow.

2.

Cut out as much wood as needed so the bar will reach from both sides. Remove the saw. 3. Start a bore cut at the normal level for a back cut, again using the lower quadrant of the bar. 4. Bore straight in, leaving enough hinge wood for the size of the tree. Walk the saw back, cutting approximately half the tree.

Dec 07, Certified arborist Mark Chisholm provides helpful and important safety tips for professionals on how to fell a bushfalling.bar all the Pro Tips videos here: http. Dec 09, To fell a tree with a chainsaw, first position your chainsaw feet off the ground and at a 70°angle, and cut a notch ⅓ of the way through the tree trunk. Then, make a horizontal cut at the base of the notch, also ⅓ of the way through. Next, use the tip of your chainsaw to make a bore cut from a couple of inches past the notch to the opposite side of the tree %(6).

If the tree starts to die in other places, it may need to come down entirely.

Jan 31, Make 1 partial cut on the limb close to the tree trunk, then make a second cut a little further down on the limb to remove most of the branch. Cut your tree limb a final time just outside the branch collar.

Always cut the limb properly so tree Views: K.